型号TL052
品牌
分类通用运算放大器
描述双路、30V、3.3MHz、高压摆率 (20V/µs)、1.5mV 失调电压、输入接近 V+、JFET 输入运算放大器
相关操作
产品概述

参数

Number of channels 2
Total supply voltage (+5 V = 5, ±5 V = 10) (max) (V) 30
Total supply voltage (+5 V = 5, ±5 V = 10) (min) (V) 10
Rail-to-rail In to V+
GBW (typ) (MHz) 3.3
Slew rate (typ) (V/µs) 20
Vos (offset voltage at 25°C) (max) (mV) 1.5
Iq per channel (typ) (mA) 2.7
Vn at 1 kHz (typ) (nV√Hz) 18
Rating Catalog
Operating temperature range (°C) -40 to 85, 0 to 70
Offset drift (typ) (V/°C) 0.000006
Input bias current (max) (pA) 200
CMRR (typ) (dB) 93
Iout (typ) (A) 0.042
Architecture FET
Input common mode headroom (to negative supply) (typ) (V) 2.7
Input common mode headroom (to positive supply) (typ) (V) 0.6
Output swing headroom (to negative supply) (typ) (V) 1.8
Output swing headroom (to positive supply) (typ) (V) -1.1

封装 | 引脚 | 尺寸

PDIP (P) 8 92.5083 mm² 9.81 x 9.43
SOIC (D) 8 29.4 mm² 4.9 x 6
SOP (PS) 8 48.36 mm² 6.2 x 7.8

特性

  • Direct Upgrades to TL07x and TL08x BiFET Operational Amplifiers
  • Faster Slew Rate (20 V/µs Typ) Without Increased Power Consumption
  • On-Chip Offset-Voltage Trimming for Improved DC Performance and Precision Grades Are Available (1.5 mV, TL051A)

说明

The TL05x series of JFET-input operational amplifiers offers improved dc and ac characteristics over the TL07x and TL08x families of BiFET operational amplifiers. On-chip Zener trimming of offset voltage yields precision grades as low as 1.5 mV (TL051A) for greater accuracy in dc-coupled applications. Texas Instruments improved BiFET process and optimized designs also yield improved bandwidth and slew rate without increased power consumption. The TL05x devices are pin-compatible with the TL07x and TL08x and can be used to upgrade existing circuits or for optimal performance in new designs.

BiFET operational amplifiers offer the inherently higher input impedance of the JFET-input transistors, without sacrificing the output drive associated with bipolar amplifiers. This makes them better suited for interfacing with high-impedance sensors or very low-level ac signals. They also feature inherently better ac response than bipolar or CMOS devices having comparable power consumption.

The TL05x family was designed to offer higher precision and better ac response than the TL08x, with the low noise floor of the TL07x. Designers requiring significantly faster ac response or ensured lower noise should consider the Excalibur TLE208x and TLE207x families of BiFET operational amplifiers.

Because BiFET operational amplifiers are designed for use with dual power supplies, care must be taken to observe common-mode input voltage limits and output swing when operating from a single supply. DC biasing of the input signal is required, and loads should be terminated to a virtual-ground node at mid-supply. Texas Instruments TLE2426 integrated virtual ground generator is useful when operating BiFET amplifiers from single supplies.

The TL05x are fully specified at ±15 V and ±5 V. For operation in low-voltage and/or single-supply systems, Texas Instruments LinCMOS families of operational amplifiers (TLC-prefix) are recommended. When moving from BiFET to CMOS amplifiers, particular attention should be paid to the slew rate and bandwidth requirements, and also the output loading.